BTL Terapia de microondas Terapia de onda corta y microondas La diatermia de microondas BTL es un equipo controlado por microprocesador. d Mikrowellendiathermief f diathermie fpar des micro-ondes p diatermia fpor microondas migraine (Med.) (Affecting one side (one the temporal regions) of the . de diatermia por micro-ondas. Maria das Graças AngueraI, Reinaldo José GianiniII. ORIGINAL ARTICLE / ARTIGO ORIGINAL. IGraduate Program in Preventive.

Author: Malakasa Gujin
Country: Iraq
Language: English (Spanish)
Genre: Literature
Published (Last): 9 August 2015
Pages: 453
PDF File Size: 7.16 Mb
ePub File Size: 7.24 Mb
ISBN: 884-7-34575-526-8
Downloads: 88981
Price: Free* [*Free Regsitration Required]
Uploader: Gurn

This method benefits the amass of the particles in both electrodes due to the high frequencies. La componente transversal del diatermix magnetico disperso se compenso con ayuda de corrientes procedentes de circuitos correctores especiales. Lorsqu’on augmente la densite initiale, la temperature consecutive au chauffage est plus faible et la compression ne peut s’operer. Full Text Available Objetivo: In addition, two hours after tissue cooling, PS had not returned to baseline Figure 3.

Aniline, diatemria and electrodes of silver Ag and copper Cu were used in a cylindrical reactor coupled with an external coil to generate glow discharges. With regard to surface technologies, many reported investigations focus on Vacuum Thermal Spray to provide NiTi coatings with minimal oxide content.

Although the study by Mortari et al.

plasma por microondas: Topics by

The results obtained indicate that drying times can be reduced drastically and that parts with diferent geometries and sizes do not pose a problem. Green disks were obtained by thermal consolidation of diatwrmia aqueous suspensions of the ceramic powders Thus, the influence of the heat flux direction on the sample crystallization was verified.

The FFA values during microwave frying increased progressively from 0. For the quantitative analysis two analytical techniques were used: Diztermia is an Open Access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

In the chapter 2 it is made a general revision on modification of surfaces, as well as the properties that were modified in polymeric materials micrpondas were exposed to plasma in previous works.


El interferometro de 2 mm del Tokamak TJ Into both reactors, the precursor was applied in a palletized form to react. In an unidimensional model is shown in the cases of a semi limited plasma and a layer of plasma the excitement mechanism of electrostatic fields for a radiofrequency wave RF polarized lineally.

As a titanium precursor, an anatase complex with hydrogen peroxide were used. The reaction-sintering by microwave heating power: In order to minimize possible late effects of thermo-therapeutic resources, the sample was divided into two groups, half performed cryotherapy application and half performed MD application on the first day, on the next day, applications on the same volunteers were reversed Figure 2.

Effect of heat preconditioning by microwave hyperthermia on human skeletal muscle after eccentric diatermua.

This low wear resistance was mainly influenced by the columnar structure within their lamellae, which caused a greater detachment of particles in the contact diatermoa during the ball-disc tests, increasing its wear. The characterization of the polymers it was carried out by FT-lR, it shows the C-Cl vibration that it is confirmed with the X-ray photoelectron spectroscopy technique XPS.

The chemical structure of the polymeric coatings contain crosslinked structures that correspond to links between monomers with the participation of all atoms, states that suggest monomer fragmentation and oxidation and states that indicate oxygen bridges in the polymers. Some experimental results obtained under different discharge conditions are also given.

There was significant increase in peak strength PS up to 15 minutes after cryotherapy, then there was a decrease in maximum isometric strength, however, statistically significant difference remained up to 1 hour and 30 minutes after cryotherapy.

The aim of this study was to compare the effects of cryotherapy and xiatermia diathermy application on the strength production capacity of the elbow flexor muscles. Due to its high toxicity, thallium has been considered by the US Environmental Protection Agency as one of the priority pollutants to be controlled.

Carmen Pérez

S e P torrados por 9 e 15 minutos e I torrado por 9, 12 e 15 minutos. After the treatment, the material was characterized in terms of its thermal, by DSC, dynamic-mechanical, by DMA and rheological, by capillary rheometry, properties. The as sprayed surface is rough and sensitive to erosion.


With the development of the proposed technology and the material for the vitreous matrix, be rotted to try in a future a great variety of mixed waste. In this process the energy is transferred directly to the material through the interaction between molecules of the material with the electromagnetic field. A form of accelerating the degradation is exposing it to plasma with reactive atmospheres.

In the first stage, the kinetic constant for the pre-treatment MW1 was J Appl Physiol ;55 microodas The oil yield of orange seed cold pressing was around The methodology for the electron temperature calculation and the density of the plasma in both cases is given, starting from the characteristic curve of the probe, as well as the approaches for the correct application of this diagnostic method of the plasma.

Microwave radiation offers an important opportunity to fulfil theserequirements, besides representing a method for the production of aligned micoondas nanotubes in multi-layers that can be valuable forinvestigation, specifically in the biosensors design, purification systems, nanosystems of cathodic emission, catalytic electrodes for fuelcells, etc.

Dois ciclos de secagem foram testados: Ablation and formation by plasma of silver metallic films on poly aniline; Ablacion y formacion por plasma de peliculas metalicas de plata sobre polianilina. Tetragonal zirconia phase was predominant in the zirconia-yttria and zirconia-ceria coatings and despite this behavior; they did not have a good performance in the wear tests. In the dynamic model, the release was performed with 5 mg of the mixture in 10 ml of solution, 1.

The mean PS values of microwave diathermy were: The effect of the pre-treatment on the kinetics of the process was also studied.